Power entry feed 72" hard wire

Our electrical system is rated for 20 Amps per circuit allowing the use of two circuits (circuit 1 and 2
only). The conductors are 12 AWG with two line conductors sharing a neutral and a ground. Our
system can be wired in both single and three-phase configurations, 240/120V, 208/120V respectively.
Under NEC requirements, users can connect up to 13 duplex receptacles per circuit, or a maximum
of 26 (15 A) duplex receptacles per power infeed. However, the actual number of receptacles
recommended on a circuit or infeed will vary depending on load requirements. 

Hardwire Power Infeed
- Installed at the wall or floor
- Must be installed by licensed electrician
- Provides 20 Amp rated, 2 circuit system
- No Connection sequence required.